TESCO
Crystal Seal does not apply a surface coating, but is a complete, highly
penetrating process in which it penetrates the matrix, marble, tile or any
masonry surface to insure a thorough and complete seal, making the surface
impervious to stains of oils, greases, water, acids, or practically any type of
common chemical discoloration.
TESCO
Crystal Seal is the only clear resin sealer that permits a permanent exterior
application without discoloration and will intensifies color and natural beauty
of stone, terrazzo and masonry surfaces. TESCO Crystal Seal penetrates into
pores and increases density and durability, keeping dirt and moisture on top of
surface so that they are easily cleaned. Extremely resistant to ultraviolet rays
and will not discolor or amber. Tests indicate that TESCO Crystal Seal has
better anti-slip properties than most other sealers.
For this reason TESCO Crystal Seal has become one of the largest selling
sealers for the flooring industry, including terrazzo, epoxy terrazzo, polyester
terrazzo, magnesite, marble, slate,
tile, brick, cement and concrete.
TESCO
Crystal Seal is used in airports, colleges, malls, banks, aircraft hangars,
warehouses and factories where a complete, dust proof, long-wearing surface is
required.
TESCO
Crystal Seal is the only clear resin sealer that permits a permanent exterior
application without discoloration.
DIRECTIONS:
-
Clean
surface with TESCO Clean'Brite, rinse surface thoroughly and allow to dry
completely. When renovating an old floor strip surface with TESCO Stripper
and then wash surface with TESCO Clean'Brite, rinse surface thoroughly and
allow to dry completely.
-
Stir
TESCO Crystal Seal well.
-
Apply
TESCO Crystal to clean, dried area using a lambs wool applicator, natural
brush or spray with low-pressure garden-type sprayer.
Mop or rollers are NOT recommended.
-
TESCO
Crystal Seal is a VERY quick drying seal.
Apply seal in one direction only.
Avoid overlapping. Do not go back over seal just applied as it will
re-dissolve original seal, causing gumming or streaking.
Use dividing strip, grout joint, or edges and borders for
overlap-joints where possible.
-
Let
TESCO Crystal Seal penetrate and dry thoroughly (normally 3-4 hours) before
exposing to foot traffic.
-
If
a second coat is desired, it is best to allow first coat to dry for
approximately 24 hours.
-
Clean
tools, applicators and spray equipment with TESCO Crystal Seal Reducer.
COVERAGE:
300 to 600 square feet per gallon, depending on porosity of surface
material.
WHAT
TO WATCH FOR: TESCO Crystal Seal is FLAMMABLE. Keep away
from heat and open flame. Keep container closed. Stir thoroughly and apply only
to completely dried surfaces. This product is not to be used where hydrostatic
conditions are present. If applied to damp surface, seal will dry cloudy and may
take from two to three weeks for cloudiness to disappear, if at all. Use with
adequate ventilation and avoid prolonged breathing or skin contact.
